8 Basic Steps To Setting Up A Shower Pan

The techniques for setting up a shower pan begin with the placement of framing square, followed by planning of the drain, installation of the shower drain tube, installation of the shower drain fitting, ranking up of the shower pan, planning and also apply the bedding materials, positioning of the shower pan in position, and lastly use of the finishing details.



Shower pans are considered the portion of a bathroom shower booth that you stand on while showering. The pan will keep your house from being ruined by water, while at the same time supporting the user's bodyweight. Several homeowners hire bathroom remodeling contractors to setup their shower pans; nevertheless, you can try the project on you own. Read this article to assist you through the project.



Location of framing square



Have a framing square put on the corners where the wall studs match the floor in the location where you plan to create the shower pan. Use the square to ensure that the place where the two stud walls meet is a square. There could be a couple of corners at the meeting point of the 2 stud walls, with respect to the shower pan's design and style. If there's any part of the stud that doesn't seem right, fix this before moving forward with the other tasks.

Get ready the drain



With the aid of a jigsaw, cut a five inch by five inch square within the subfloor where the shower drain will be headed. See the supplier's instructions on the shower pan and refer to them regarding the dimensions required for the drain's place.



Build shower drain water pipe



Setup the pipe for the shower drain according to the company's guidelines that came with the item. Have the shower pan's instructions and refer to this regarding the length of the drain pipe which should stick over the floor's surface through the opening which was made in the subflooring.



Setup shower drain fitting



Setup the fitting of the shower drain in the lower part of the shower pan and on its opening by following the maker's directions on the drain. Have the shower pan positioned on the floor in a way that the drain fitting on the pan's underside will slip over the drain water pipe in the floor. As necessary, slide the pan to be sure that the pan's sides are pushed up against the wall studs.



Level the shower pan



Have a 4-foot level placed in numerous directions inside the pan. Bring the bubble of the level between the two marks by putting wood shims beneath the shower pan. By using a pencil, make a mark on top of the shower pan's set up flange. Lift the shower pan up and get it put inside. Then, eliminate the shims.



Make and utilize bedding materials



Make the bedding material that the maker advises, which is typically mortar or perhaps plaster, by mixing it based on the guidelines located in the bag. Put the bedding material onto the floor where you'll have the shower pan entirely put and spread it by using a trowel. Make sure that you have an ample amount of bedding materials to support the shower pan's whole underside.



Put shower pan in place



Before the bedding materials sets, get the shower pan placed over it. Make sure that the drain fitting located on the bottom of the pan would slide over the drain pipe which will emerge right through the floor. Press down on the shower pan in an even manner until you discover that the installation flange gets to the markings on the studs that you made earlier. Ensure that the pan's front side edge is touching the subflooring.



Use finishing touches



Allow the bedding material set. Put cement board or drywall on the wall studs and also over the pan's set up flange. Keep a 1/8-inch gap between the cement board or drywall and the shower pan's dash rim.



Since this job and the things necessary to it cost money, it is important that you plan the task well. Do thorough research, and do not attempt the project until you feel that you are totally ready.